67 CHANNEL
2-WAY ANTENNA
TV SET COUPLER
Model CC-7870
(75 ohm)
Made in U.S.A.
Winegard Company
3000 Kirkwood St., Burlington, IA. 52601
INSTRUCTIONS
CONSUMER 90 DAY WARRANTY
The Winegard Company warrants this Winegard product against any
defects in materials or workmanship within 90 (ninety) days from date of
purchase. No warranty claim will be honored unless at the time the claim is
made, you present proof of purchase to an authorized Winegard dealer (if
unknown, please contact Winegard Company, 3000 Kirkwood Street,
Burlington, IA 52601-2000, Telephone 800-288-8094).
Winegard Company (at its option) will either repair or replace the
defective product at no charge to you. This warranty covers parts, but
does not cover any costs incurred in removal, shipping or reinstalla-
tion of the product. The warranty does not extend to products which
have been subjected to misuse, improper installation, or to damage
caused by wind, lightning, ice or other occurrences over which the
manufacturer has no control.
The 90 Day Warranty is provided on the condition that the
equipment is properly delivered with all handling and freight charges
prepaid to your Winegard dealer for return to our factory for repair or
replacement. Winegard dealers will arrange for the replacement or
repair and return to you without charge the product which failed due
to defective material or workmanship.
WINEGARD COMPANY WILL NOT ASSUME ANY LIABILITIES
FOR ANY OTHER WARRANTIES, EXPRESS OR IMPLIED, MADE
BY ANY OTHER PERSON.
ALL OTHER WARRANTIES WHETHER EXPRESS, IMPLIED OR
STATUTORY INCLUDING WARRANTIES OF FITNESS FOR A
PARTICULAR PURPOSE AND MERCHANTABILITY ARE LIMITED
TO THE 90-DAY PERIOD OF THIS WARRANTY.
The foregoing shall be the sole and exclusive remedy of any
person, whether in contract, tort or otherwise, and Winegard shall not
be liable for incidental or consequential damage or commerical loss,
or from any other loss or damage except as set forth above.
Some states do not allow limitations on how long an implied
warranty lasts, or the exclusion of limitation of incidental or conse-
quential damages, so the above limitations or exclusions may not
apply to you.
This warranty gives you specific legal rights and you may also have
other rights which vary from state to state.
Rev 2/08.
The CC-7870 couples two 75 ohm leads from
any two antennas to a 75 ohm downlead. Input
and output are thru standard 75 ohm F-jacks.
AC-DC passive input to Set 1 side. Three FC-
5910 connectors provided. -3.5 insertion loss.
INSTRUCTIONS
DESCRIPTION FOR
COUPLING TWO ANTENNAS
STEP 1. Install FC-5910 connectors on coax
cables per instructions on back of sheet.
STEP 2. Attach antenna downlead to jack
marked "Antenna" and antenna cables to jacks
marked "Set 1" and "Set 2". See illustration.
STEP 3. Mount coupler with screws and bracket
as shown.
WAYS TO MOUNT COUPLER
Printed in U.S.A. 2451860 Rev. 3/97
INSTALLING FC-5910
CONNECTORS ON COAX CABLE
STEP 1: Strip outer cover back 1/2"* from end of
cable. Fray braid back as far as outer cover will allow.
STEP 2: Trim braid close to outer cover and remove
1/4"* of inner insulation being careful not to nick
center conductor. Make sure no foil or braid can
touch center conductor.
STEP 3: Slide connector tip between braid and inner
insulation (braid and foil, on foil shield cable) and push
connector on cable as far as it will go. Crimp built-in
ferrule with proper crimping tool. Hex connector
requires hex crimping tool. Do Not crush cable out-
of-round.
* If installing in very hot weather, increase these dimensions 1/8".
DESCRIPTION FOR SPLITTING A SINGLE
COAX LINE FOR SECOND TV HOOK-UP
INSTRUCTIONS
STEP 1. Install FC-5910 connectors on coax
cables per instructions on back of sheet.
STEP 2. Attach antenna downlead to jack
marked "Antenna" and antenna cables to jacks
marked "Set 1" and "Set 2".
STEP 3. Mount coupler with screws and bracket
as shown.
