RTA CUBE
ASSEMBLY INSTRUCTIONS
Using a #2 Phillips screwdriver, install the
camlock pins into the pre-drilled holes in
the (4) kick base boards. (See Figure 1)
Install camlocks into the large holes in the
kick base boards and tap into position with
the rubber mallet. (See Figure 2)
NOTE:
Ensure the hole in the side of the
camlock faces outward.
Arrange the (4) kick base boards to form
a square. At each corner of the square, set
the camlock pins of one board into the cam-
locks of the adjacent board. (See Figure 3)
Connect the camlocks and pins by inserting
the screwdriver into the top hole of the cam-
lock and turning clockwise. (See Figure 4)
PRO TIP:
Tilt the screwdriver at an upward angle
while twisting to better lock the camlocks.
1
2
3
4
TOOLS NEEDED
Confirmat Screw x 20
Camlock x 12
Cube Panel x 4
Dowel Pin x 8
Screw Cap x 20
Kick Base Board x 4
Spinner Base Top x 1
Camlock Pin x 12
Pan Head Screw x 16
Caster x 4
Cube Top x 1
KIT COMPONENTS
KICK BASE ASSEMBLY
windmillslatwall.com
Made in USA
1-800-548-7528
#2 Phillips Screwdriver
Rubber Mallet
(optional)
