RTA 4-WAY WINGS
ASSEMBLY INSTRUCTIONS
Using a #2 Phillips screwdriver, install the camlock
pins into the pre-drilled holes in the (4) kick base
boards. (See Figure 1)
Install camlocks into the large holes in the kick
base boards and tap into position with the rubber
mallet. (See Figure 2)
NOTE:
Ensure the hole in the side of the camlock
faces outward.
Arrange the (4) kick base boards to form a square.
At each corner of the square, set the camlock pins
of one board into the camlocks of the adjacent
board. (See Figure 3)
Connect the camlocks and pins by inserting the
screwdriver into the top hole of the camlock and
turning clockwise. (See Figure 4)
PRO TIP:
Tilt the screwdriver at an upward angle while
twisting to better lock the camlocks.
1
2
3
4
TOOLS NEEDED
windmillslatwall.com
Made in USA
1-800-548-7528
#2 Phillips Screwdriver
Rubber Mallet
(optional)
KICK BASE ASSEMBLY
Confirmat Screw x 12
Camlock x 12
Wing Panel x 4
Dowel Pin x 4
Screw Cap x 12
Kick Base Board x 4
Spinner Base Top x 1
Camlock Pin x 12
Pan Head Screw x 16
Caster x 4
KIT COMPONENTS
