Wincor Nixdorf TH420, Руководство пользователя

Страница: 47 / 64

You must use a check to conduct the test. The test will not run if a slip or
form is inserted.
n
Push paper feed button.
The check is flipped and returned, but no printing is performed.
To exit the check flip test mode:
n
Enter the configuration menu and “Diagnostic Modes” sub-menu again.
n
Disable the Check flip test mode.
n
Exit the configuration menu.
The printer is on-line and can again normally communicate with the host
computer.
Printer settings and functions
To change the printer settings and functions, enter the configuration menu,
select the submenu from the main menu and answer the questions printed
on the receipt until you come to the instructions for selecting the printer
settings.
Be extremely careful changing any of the printer settings to avoid
inadvertently changing other settings that might affect the performance of
the printer.
If it becomes necessary to clear lasting printer tallies, please contact an
Wincor Nixdorf representative for instructions.
Press the paper feed button as instructed to select the printer settings you
want.
Se lect the emu la ti on/soft wa re op tions sub-menu to set
n
Printer ID mode
This functi on is used to de ter mi ne what prin ter ID va lue is re tur ned in re -
spon se to a Trans mit prin ter ID com mand (1D 49 n) when the prin ter is in
emu la ti on mode. The prin ter can be con fi gu red to send back the ID of the
TH420.
n
Default lines per inch
This function allows you to set the default for lines per inch to either:
8.13 lines per inch
7.52 lines per inch
6.77 lines per inch
6.00 lines per inch
41
PRINTER SETTINGS AND FUNCTIONS