Wincor Nixdorf TH200, Руководство программиста

Страница: 46 / 106

Programmer’s Guide
TH200
46
GS ( A pL pH n m Execute test print
Code:
Range:
Description:
Notes:
ASCII GS ( A pL pH n m
Hex 1D 28 41 pL pH n m
Decimal 29 40 65 pL pH n m
(pL + (pH × 56)) = 2 (where pL=2, pH=0)
0
≤
n
≤
2, 8
≤
n
≤
50
1
≤
m
≤
3, 9
≤
m
≤
51

Executes a test print with a specified test pattern on a specified paper.

pL and pH specifies the number of the parameter such as n, m to (pL + (pH × 256))
bytes.
n specifies the paper to be tested.
n Paper
0, 48 Basic sheet (paper roll)
1, 49
2, 50
Paper roll
m specifies a test pattern.
m Test pattern
1, 49 Hexadecimal dump
2, 50 Printer status print
3, 51 Rolling pattern print

This command is enabled only when processed at the beginning of a line in standard
mode.

This command is no effect in page mode.

When this command is received during macro definition, the printer ends macro
definition and begins performing this command.

After the test print is finished, the printer resets itself automatically. Therefore, the
already-defined data before this command is executed, such as an user-defined
characters, downloaded bit image, and macro, becomes undefined, and the receive
buffer and print buffer are cleared, and each setting returns to the default value. The
printer also re-reads the DIP switch settings.

The printer cuts the paper at the end of the test print.

The printer goes BUSY while this command is executed.