Wincor Nixdorf CINEO C1030, Руководство по установке, Страница: 12 / 35

Customer Requierements
8
Requirements
Before the CINEO C1030 installation can be started, the customer is held responsible to
provide the following:
•
Appropriate drawings concerning location of the equipment as well as site wiring
(power and communications, paths and lengths). Location of other equipment that
may generate electrical noise, electromagnetic interference or heat.
•
Provision and installation of all communication cables wall jacks, special connectors
and associated hardware.
•
Provision and installation of necessary power distribution boxes, conduits, grounds,
lightning protection devices and associated hardware
•
Ensure that all applicable codes, regulations and laws (including, but not limited to,
electrical, building, safety and health) are adhered to.
• Provision and installation of auxiliary power or other equipment as required.
• Provision of storage or service as required.
• Provision of a level floor to locate the CINEO C1030. The system has to be stable and
must not tilt. The maximum incline must not exceed 2%. The feet of the unit can
overcome a height difference of up to 10 mm.
•
Provision and installation of floor coverings and environmental systems that limit or
control static electricity build-up and discharge.
•
Provision of appropriate equipment for the remote support.
The customer is responsible for relocating the CINEO C1030 equipment (check stand and
components) to the final placement/installation position.
Keep the Wincor Nixdorf equipment area free from dust, smoke, lint, and other particles.
Restrict smoking, eating, and drinking around the equipment. Avoid locating the equipment
near other machines that generate ink, carbon and paper dust particles.
Please note that Wincor Nixdorf will not take over any warranty/liability in case the
technical and environmental requirements are not met.