Winco DR450V4, Инструкция по установке и эксплуатации

Страница: 17 / 24

17
OPM-155/A
9. Disconnect the battery cables, clean and charge the
batteries. Trickle charge the batteries while the
equipment is in storage. A poorly charged battery
can freeze and burst.
10. Put a note on the engine with the date, type of
conservation and the conservation oil used.
11. Cover the air filter, exhaust pipe and engine if
necessary.
12. Empty the AdBlue/DEF tank and rinse it with distilled
water.
NOTE: When storing in cold regions, make sure the
coolant and engine oil are in conditions suitable to the
environment. Also, when starting the engine after it has
been stored, make sure that there is no snow or foreign
matter that could interfere with engine startup, and
rotating parts are not frozen.
BRINGING OUT OF STORAGE
1. Remove any covers from the engine, air filter and
exhaust pipe.
2. Fill the engine with the correct quality and viscosity oil
into the engine, as necessary. Install a new oil filter if
the filter was not changed during conservation.
3. Install new fuel filters and bleed the fuel system.
4. Check the drive belt(s).
5. Check the condition of all rubber hoses, and
re-tighten the hose clamps.
6. Close the drain taps and install any drain plugs.
7. Check the coolant level. Top up as necessary.
8. Connect the fully charged batteries.
9. Start the engine and warm it up at fast idle with no
load.
10. Check that no oil, fuel or coolant leakage occurs.
SERVICE INTERVALS
Check Engine Oil Level Daily
Check Coolant Level and for
Leakage
Daily
Check Air Filter Daily
Check Electrolyte Level in Battery
and Clean Terminals
Monthly
Drain Water from Fuel Pre-filter 500 Hours/12 Months
Check Belts and Belt Tension Monthly
Change Oil 500 Hours/12 Months
Change Oil Filters 500 Hours/12 Months
Change Fuel Filters 500 Hours/12 Months
Change Fuel Pre-filter 500 Hours/12 Months
Change Pre--filter 1000 Hours/12 Months
Change Fine Filter 1000 Hours/12 Months
Valve Clearance, Inspect & Adjust 1500 Hours
Change Air Filter (depending on
conditions)
2000 Hours
Change Coolant 8000 Hours
Change Drive Belts 2000 Hours
Change Air Filter 2000 Hours
Inspect Turbocharger, Clean if
Required
2000 Hours
* There are additional maintenance items and explanations in
the engine operator’s manual. Read thoroughly before operating
this unit.