to the appropriate connections on the
DUT.
Initiating
Master-Slave
Operation
The following paragraphs describe how to set up
both 68XXXBs to perform master-slave operations.
Use the CW Frequency Mode menu map (Chapter 4,
Figure 4-2) to follow the menu sequences.
To initiate master-slave operation, turn on both
68XXXBs and place them in CW mode. The CW
Menu (below) is displayed.
On the Master 68XXXB, press
Master Slave
to go
to the Master-Slave Menu display (below).
This menu lets you perform the following:
Go to the Slave Frequencies List menu.
Set the dF frequency for the Slave unit.
Set the Slave unit’s main power level (L1).
Set the alternate sweep power level (L2) for
the Slave unit.
Turn master-slave operation on and off.
Press
Slave Freqs
to go to the Slave Frequencies
List menu (next page).
USE WITH
MASTER-SLAVE
OTHER INSTRUMENTS
OPERATION
NOTE
Master-slave operations are always
initiated in the CW frequency
mode. Once initiated, you then can
change to a sweep frequency mode
of operation by selecting the desired
frequency mode on the Master
68XXXB.
681XXB OM
7-5
