PULL
the starter rope with a quick firm and consistent upwards motion
until the engine fires or
starts and runs.
If the engine fires (pops) but does not continue to run, move the choke lever back to the “RUN” po-
sition.
Allow the engine to warm up for 5-20 seconds.
TO START A WARM ENGINE
With the engine switch is on “I” position, PULL the starter rope with a quick firm and consistent upward
motion until the engine starts.
NOTE: Do not use the choke when starting a hot engine.
TO STOP THE ENGINE
Press the engine switch to the stop “O” position. Wait until the engine stops.
OPERATING THE POST HOLE DIGGER
See figure 7a-7b
Grip the power drill firmly with both hands and keep all parts of the body from the auger bit and
muffler.
Hold the post hole digger in front of you with the right hand firmly gripping on the throttle handle
and your left hand firmly gripping the other.
Always
keep a firm grip with both hands while in operation.
The post hole digger should be held at a comfortable position with the handle height no higher
than waist level.
The throttle trigger helps control the speed of the auger to suit carious ground conditions.
Keep a comfortable distance between yourself and the drill without overreaching.
Always pay full attention to you operation. Serious injuries may result if contact is made with rotat-
ing auger.
Note: Your post hole digger is supplied with a 300mm extension shaft to be used for deeper
hole digging. Do not start digging a hole with the extension shaft attached.
© by WilTec Wildanger Technik GmbH
Seite 36
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
