Installation (Fig. 9)
Make sure the curtain of the roller shutter has been lowered completely before beginning the installa-
tion.
Attach the drive adapter (4) to the motor (3) and measure the distance between the adapte-
rand the crown (2) before then inserting both into the roller shaft (5) with the adapter being
placed inside the shaft.
Measure the distance between the drive adapter (4) and the end of the shaft (5) in order to
avoid damaging it when fixing the motor to the roller shaft.
Insert the idler (7) into the shaft (5) on the site opposing from the motor (3) and take proper
measurements before attaching it to the shaft by using screws with a maximum length of 1
cm.
Install the motor bracket (1) and the idler bracket (8) in a way that will ensure that the roller
shaft (5) is balanced, once it has been attached.
Mount the roller shaft (5) to the brackets with the cable of the motor being placed in a way that
grants access to the adjusting screws (Fig. 12) of the crown.
Let an electrician connect the motor to the mains supply and install any kind of electric device.
Then use the controls to bring the roller shaft (5) into its lowest position (the one where the
shutter would be completely unwound). This sets the lower end position.
© by WilTec Wildanger Technik GmbH
Artikel 62455-62460
Seite 6
http://www.WilTec.de
http://www.aoyue.eu
11 2020
-1