WilTec 34208, Инструкция по эксплуатации

Страница: 5 / 11

© by WilTec Wildanger Technik GmbH Item 34208 Page 5
http://www.WilTec. de
http://www.aoyue.eu 07 2021 -1
http://www.teichtip.de
Technical specifications
Type Piston compressor with casing
Power (W) 150 (
⅕
hp)
Rotation speed (rpm) 1450
–1700
Flow rate (
ℓ
⁄
min
) 23
Pressure range (
㍴
)
0
–4
Weight (
㎏
)
5.2
Capacity
(ℓ)
3
Size (
㎜
)
310×135×350
Suitable nozzles (
㎜
)
0.2
–1.0
Sound level (dB (A)) approx. 47
Length of cable (m) 1.9
Hose connection (
㎜
)
9.51 (⅛″)
User notes
•
The compressor has a 9.51
mm (⅛″) outlet with external thread which can be effortlessly
changed to ¼″. The matching adapter is not included in the delivery.
•
When the compressor is connected by the hose to the airbrush gun, it can be connected to the
mains and switched on.
•
The maximum pressure is displayed the pressure gauge, the operating pressure can be
adjusted by the pressure regulator.
•
If the auto-stop mode is activated (repeatedly switched on/off) any and all screw fittings and
connections should be sealed by sealing tape.
Leakage check
•
Switch on the compressor and wait until the maximum pressure has built up and the auto-stop
function has been activated.
•
If there is no leakage, the pressure gauge should display nearly constantly the same range of
pressure.
•
A quick decrease of the range of pressure suggests that there is in fact a leakage.
•
It is of great importance to seal any leak as soon as possible in order to avoid any impact on
the capacity and efficiency of the compressor.
•
A leakage leads to the auto-stop and auto-start constantly being switched on and off.
Difference between maximum pressure and operating pressure
•
The maximum pressure is the highest possible pressure that a compressor is able to generate.
•
The maximum pressure is the pressure measured only inside the compressor itself.
•
Once the maximum pressure has been reached, the compressor switches off (auto-stop), and
as soon as the pressure starts to decrease, it switches on again (auto-start).
•
On the outlet of the compressor, there is a lower pressure. What remains is the pressure that
you actually work with. The operating pressure may vary according to the connected airbrush
gun.