19
OFFICE 200
CELL PHONE SIGNAL BOOSTER
NEED HELP?
______
Specifications
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot
be adjusted without factory reprogramming or disabling the hardware. The Signal Booster will amplify, but not
alter incoming and outgoing signals in order to increase coverage of authorized frequency bands only. If the
Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected. If a detected signal is
too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster will automatically
operation after a minimum of 1 minute. After 5 (five) such automatic restarts, any problematic bands are
the Signal Booster. Noise power, gain, and linearity are maintained by the Signal Booster’s microprocessor.
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation. Changes or modifications not expressly approved by weBoost could void
the authority to operate this equipment.
Office 200
™
Model Number
460047
FCC ID
PWO460047
Connectors
N-F
emale / F-Female
Antenna Impedance
50 Ohms / 75 Ohms
Frequency
698-716 MHz, 729-756 MHz, 777-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz
Power output for single cell
phone (Uplink) dBm
700
MHz
Band12/17
700
MHz
Band13
800
MHz
Band 5
1700
MHz
Band 4
1900
MHz
Band 2/25
24.0
24.0
25.0
25.0
25.0
Power output for single cell
phone (Downlink) dBm
700
MHz
Band12/17
700
MHz
Band13
800
MHz
Band 5
2100
MHz
Band 4
1900
MHz
Band 2/25
15.1
15.1
15.3
15.2
15.2
Noise Figure
5 dB nominal
Isolation
> 90 dB
https://www.signalbooster.com
855.846.2654
