42
Wilo SE 08/2020
en
• Disconnect the connecting cable from the
power supply.
• Press down the locking button of the installed plug
and remove the plug from the control module.
• Observe the terminal assignment (PE, N, L).
• Connect the existing device plug to the plug
connection (11) of the control module.
7 Commissioning
Commissioning only by qualified technicians.
7.1 Venting
• Fill and vent the system correctly.
If the pump does not vent automatically:
• Activate the pump venting function via the operating
button: press and hold for 3 seconds, then release.
The pump venting function is initiated and
lasts 10 minutes.
The top and bottom LED rows flash in turn at 1 second
intervals.
• To cancel, press and hold the operating button
for 3 seconds.
sec
3
min
10
NOTICE
After venting, the LED display shows the previ
-
ously set values of the pump.
Содержание Wilo-PARA SCA Series
Страница 2: ...Fig 1 11 1 2 3 4 5 Para SCA 6 8 9 10 7...
Страница 3: ...Fig 2 Fig 3 a b Fig 4 Fig 5a Fig 5b 1 2 PE N L...
Страница 4: ...Fig 5c Fig 5d Fig 5e Fig 5f Fig 6...
Страница 6: ......
