Wilo VeroLine-IP-E 40/160-4/2 Series, Инструкция по установке и эксплуатации

Страница: 59 / 63

English
110 WILO SE 05/2015
13 Factory settings
For the factory settings, see Tab. 12 below.
Tab. 12: Factory settings
Menu
no. Designation Factory-configured values
1.0.0.0 Setpoints • Controller:
approx. 60% of n
max
pump
• Δ p-c:
approx. 50% of H
max
pump
• Δ p-v:
approx. 50% of H
max
pump
2.0.0.0 Control mode Δ p-c activated
3.0.0.0 Δ p-v gradient Lowest value
2.3.3.0 Pump ON
4.3.1.0 Base-load pump MA
5.1.1.0 Operating mode Main/standby mode
5.1.3.2 Internal/external pump
cycling
Internal
5.1.3.3 Pump cycling time interval 24 h
5.1.4.0 Pump enabled/disabled Enabled
5.1.5.0 SSM Collective fault signal
5.1.6.0 SBM Collective run signal
5.1.7.0 External off Collective external off
5.3.2.0 In1 (value range) 0–10 V active
5.4.1.0 In2 active/inactive OFF
5.4.2.0 In2 (value range) 0-10 V
5.5.0.0 PID parameter See chapter 9.4 “Setting the con-
trol mode” on page 95
5.6.1.0 HV/AC HV
5.6.2.0 Emergency operation speed approx. 60% of n
max
pump
5.6.3.0 Auto reset time 300 s
5.7.1.0 Display orientation Display on original orientation
5.7.2.0 Pressure value correction Active
5.7.6.0 SBM function SBM: Run signal
5.8.1.1 Pump kick active/inactive ON
5.8.1.2 Pump kick interval 24 h
5.8.1.3 Pump kick speed n
min