Wilo Helix2.0-VE, Инструкция по установке и эксплуатации

Страница: 52 / 92

en
52 Installation and operating instructions • Drive for Wilo-Helix2.0-VE / Wilo-Medana CH3-LE • Ed.01/2022-06
• The communication between the main pump and the standby pump is interrupted. The
standby pump starts immediately after detecting a fault.
12.2 Settings menu In the “Double pump management” menu, a double pump connection can be established or
disconnected and also the double pump function can be adjusted.
The menu Settings
Double pump management
Settings
Monitoring settings
External interfaces
Dual pump management
has different sub-menus depending on the status of the double pump connection. If a
double pump connection is present, the following setting is possible:
Universal Display text
1.4 Double pump management
1.4.1 Connect double pump
1.4.1.1 Double pump partner address
1.4.1.2 Establish double pump pairing
1.4.2 Disconnect double pump
1.4.3 Double pump function
1.4.3.1 Duty/Standby
1.4.4 Pump cycling
1.4.4.1 Time-based pump cycling: ON/OFF
1.4.4.2 Time-based pump cycling: interval
1.4.4.3 Manual pump cycling
• Connecting double pump
Double pump
management
Connect double pump
If the double pump connection is not present, the following settings are possible:
• Disconnecting double pump
• Double pump function
• Pump cycling
Double pump
management
Disconnect double pump
Double pump function
Pump cycling
Menu “Connecting double pump”
If double pump connection is not yet established, in the “Settings” menu , select
Universal Display text
1.4 Double pump management
1.4.1 Connect double pump
1.4.1.1 Double pump partner address
1.4.1.2 Establish double pump pairing
1. "Double pump management"
2. "Connecting double pump"