![Williams Sound PA R750 Скачать руководство пользователя страница 1](http://html1.mh-extra.com/html/williams-sound/pa-r750/pa-r750_overview_982284001.webp)
O
VERVIEW
The PPA R750 Monitor Receiver is designed for use with Williams Sound PERSONAL PA
®
(PPA) Wide-band FM Transmitters. With the R750, small groups of people can listen to the FM
broadcast in a cry room, nursery, office area, or any location where a remote speaker is needed
and wiring is difficult to run.
U
SING THE
R750 R
ECEIVER
Step 1:
Insert the ANT 026 Antenna into the “Antenna” connection on the back of the unit.
(See Figure 2.) Make sure it is fully inserted and tightly fitted.
Step 2:
Extend the antenna by grasping the tip and pulling straight upward.
Step 2:
Insert the PLC 013 Plastic Clip into the hole provided. (See Figure 2.) Push the clip in
until it snaps into place.
Step 4:
Lock the antenna shaft into the clip so that it will not rotate or fall over.
Step 5:
Plug the AC power cord into an AC outlet and turn the power switch on.
Step 6:
Make sure your PPA Transmitter is on and has an active audio source. Adjust the
volume control on the R750 until you hear the broadcast.
Note:
The R750 will normally receive the FM broadcast up to 150 feet away from the
Transmitter.
Power
24VAC, CT
50-60Hz, 15W
On
Off
TREBLE
BASS
VOLUME
FM Receiver Model R750
This device complies with FCC Rules Part 15. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference and (2) this device must accept any interference that
may be received, including interference that may cause
undesired operation.
FCC ID: CNMR750
Williams Sound Corp. Eden Prairie, MN 55344
Williams Sound Corp.
F
IGURE
1: R750 R
EAR
P
ANEL
F
EATURES
Telescoping Antenna (ANT 026)
Antenna Connector
Plastic Antenna Clip (PLC 013).
Power On/OFF Switch
Volume, Treble, and Bass Controls
AC Power Supply
PPA R750 Monitor Receiver
FM Listening System Receiver
Williams Sound
®
Helping People Hear