Digi-Wave
Connect
DWD 401
USER GUIDE
Digi-Wave Connect is an analog audio cable converter box
that sends audio to and from an existing Digi-Wave 400
system. By connecting your Digi-Wave Connect to your
local audio system, you can transmit sound from your audio
equipment to your Digi-Wave group, or output the audio
from your Digi-Wave group to your local sound system.
The USB cable connects the audio in, audio out from the
Digi-Wave DLT Transceiver and provides it to the Digi-Wave
Connect.
Powering On and Charging
Connect the power cable to the power port on the Digi-
Wave connect.
Once USB cable is connected to the DLT Transceiver from
the Digi-Wave Connect, the LED on the top of the DLT
transceiver will light up. The device will charge and stay
charged while connected.
Connecting a DLT
A USB 3.1 type C cable is included with the Digi-Wave
Connect and is used to connect a DLT transceiver to the
Digi-Wave Connect.
NOTE: A Standard USB 2 type C will not work. Make sure
you are using the cable included with the system or
another USB 3.1 type C cable.
Insert one end of the USB 3.1 type C cable into the bottom
of the Digi-Wave DLT transceiver, and insert the other end
into the DLT port on the Digi-Wave Connect.
No special settings for the DLT transceiver are required for
the Digi-Wave connect to work, although settings such as
line in/out gain can be adjusted as desired.
The DLT transceiver will constantly transmit sound once
connected to the Digi-Wave Connect, even without the
use of the TALK button. To stop the transmission of audio,
disconnect the DLT transceiver from the Digi-Wave Connect.
Connecting a DLR
A DLR receiver will not provide the same functionality as
connecting a DLT transceiver. A DLR receiver does not
have a talk feature and cannot transmit sound to the Digi-
Wave group.
The DLR receiver can be used only for sending sound from
a Digi-Wave group to a local sound system. If sound does
not need to be sent to other Digi-Wave devices, this setup
may be suitable.
Connecting the Bracket to the Digi-Wave Connect
Attaching the Bracket
A bracket (BKT 040) is included with the DWD 401. This
bracket can be used to mount the Digi-Wave device to the
top of the Digi-Wave Connect.
To prevent scratching, remove the lining from the two
pieces of cork and attach the each piece of cork to the long
edges on bottom of the bracket.
Place the provided shoulder washer into the bottom of the
center hole on the base of the bracket. Insert the provided
large screw with the round black head from the top of the
base of the bracket through the center hole at the bottom
of the bracket and into the shoulder washer.
There is another hole in the top of the Digi-Wave Connect
that the bracket can be screwed into. Twist the large black
screw into this hole until the bracket is secured to the top of
the Digi-Wave Connect.
Place your Digi-Wave device in the upper part of the
bracket. Ensure that the USB 3.1 type cable is properly
connected.
