Will Burt 902404, Руководство оператора

Страница: 7 / 16

Compressor (902404) and Pneumatic System
TP-4945001-00 vii
SAFETY SUMMARY
SIGNAL WORD DEFINITION
Per the ANSI Z535.4 standard, the following signal words and definitions are used to indicate hazardous
situations:
DANGER indicates an imminently hazardous situation that, if not avoided, will result in death or
serious injury.
WARNING indicates a potentially hazardous situation that, if not avoided, could result in death or
serious injury.
CAUTION indicates a potentially hazardous situation that, if not avoided, may result in minor or
moderate injury. It is also used to alert against unsafe practices.
GENERAL SAFETY PRECAUTIONS
The following are general safety precautions that are not related to any specific procedures and therefore
do not appear elsewhere in this publication. These are recommended precautions that personnel must
understand and apply during many phases of operation and maintenance.
Electrocution Hazard! Contact with high voltage will result in death or serious injury. Observe
general safety precautions for handling equipment using high voltage. Do not locate or operate
mast near electrical lines, cables or other unwanted sources of electricity. Do not operate mast in
lightning. Be certain electrical cables are undamaged and properly terminated. Always
disconnect power at the breaker box of the unit before performing service, repair or test
operations. The breaker box is located on the rear, inner wall of the base panel, just above the
base of the stowed mast. Open the hinged door of the box and flip the breakers to the OFF
position before removing the cover.
Safety Instruction - Read Manual! Failure to follow operating instructions could result in death
or serious injury. Read and understand the operator’s manual before using the mast.
Tip Over Hazard! Mast tip over could result in death or serious injury. Do not operate in high
winds. Operate on level ground only. Stand clear of mast and mast payload during operation.
Be certain mast is level and secure before and during installation, operation and maintenance.