WMR400 Operation Manual
Operation
Wiligear WMR-400 is a high power miniPCI card to be used in outdoor wireless
systems. Please follow the following instruction while using this card. This card is
meant to be operated (and used) by system integrators who are aware of the
regulatory requirements in the area it is being used. The following instructions
need to be followed while using the card
1) Before inserting the card in a host PC board, please power down the host
PC board first
2) The antenna port (MMCX connector) should be connected to the
appropriate load or antenna before powering up the host board. Lack of
Antenna (or load) while the WMR-400 is powered up will cause severe
damage to the card
3) Please make sure any person handling the card with bare hands follows
proper ESD precaustions. Improper handling could cause ESD damage.
4) The card should not be tampered or modified in any way. Tampering or
modification could cause the card to fail standard tests
FCC Information
Electronic Emission Notices
This device complies with CFR 47 Part 15 of the FCC rules.
Operation is subject to the following two conditions:
·
This device may not cause harmful interference.
·
This device must accept any interference received, including interference that may cause
undesired operation.
FCC Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to CFR47 Part 15. These limits are designed to provide
reasonable protection against harmful interference when the equipment is
operated in a residential environment, not withstanding use in commercial,
business and industrial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. There is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning
