WHS, Mono|DuoLED, WelcomeConsole-EXT, WPEHS - Quick Start Guide - Phones Accessories
WHS, Mono|DuoLED, WelcomeConsole-EXT, WPEHS - Quick Start Guide - Phones Accessories
Page 4 of 11
Connection to W-AIR LifeSaver/ W-AIR Med/ W-AIR Office
Make sure the headset is switched on:
Press and hold the receiver button
, until the blue LED starts flashing
Go to the Wildix W-AIR LifeSaver/ W-AIR Med/ W-AIR Office handset’s Settings menu -> Bluetooth and
select Enable Bluetooth
Select Search for devices
Select Wildix WHS-BT headset (the chipset number is shown) from the list of available bluetooth devices
and select Pair
Enter the PIN: 0000
When connected, the headset’s blue and green LEDs turn on for several seconds and a voice prompt says "
Connected".
Answer / End a call
Proceed as follows:
To answer or to end a call, press the receiver button
on the headset
The blue and green LEDs flash twice
During the conversation the LED is off
MonoLED, DuoLED
Packing list
1 x MonoLED/ DuoLED headset
1 x table stand
1 x portable case
1 x spare ear pads
1 x USB Type-A adapter
Compatibility
WorkForce, WelcomeConsole (full status LEDs support coming later)
Vision, SuperVision (full status LEDs support coming later)
Apple Mac, Windows PC
Features
USB Type-C plug
USB adapter included
Answer/ Hangup/ Mute/ Volume control buttons
Status LEDs: online, away, DND, on call, ringing, call held, missed call
Table stand included
Quick Start Guide
Note: in stock at the
on June 30th.