W02/04BRI - Quick Installation Guide - English
W02/04BRI - Quick Installation Guide - English
Page 2 of 3
The gateway should be connected via Ethernet cable to the same network as the PBX or an external
DHCP server (for instance its Router)
As soon as the DHCP server assigns an IP address to the gateway, you can pass to the next step of the
gateway configuration
You should connect to the PBX in order to configure the gateway
In case the PBX is used as a DHCP server, the gateway is detected on the network automatically
In case an external DHCP server is used, check the list of the active leases to detect the IP address
assigned to the gateway
Connection to the line
On the rear panel of the BRI gateway, there are from one to four ports marked as "
". Connect your Bri
Bri1 – Bri4
lines to these ports, as it is shown on the picture below:
Provisioning and configuration of the gateway
For auto-provisioning of BRI gateway, follow our
.
For remote/unreachable media gateways behind NAT/Firewall, follow our
online Guide to remote provisioning
Reset of the gateway
