15
WIKA operating instructions analog pressure transducer CPT6030
PN 0020508001A 03/2020 EN
EN
Operation
6. Maintenance and Recalibration
For contact details, please see Chapter 1 “General information” or the back page of the operating instructions.
6.1 Maintenance
The CPT6030 was designed for maintenance-free operation. User maintenance is not recommended. If you have questions not
covered by this manual, call 1-800-984-4200 (USA only), or 1-512-396-4200 for assistance, or send an email to
6.1.1 Beyond the Warranty
Take advantage of Mensor’s expert product care. Mensor provides complete maintenance and calibration services, available for
a nominal fee. Our service staff is knowledgeable in the innermost details of all of our transducers. We maintain units that are in
operation in many different industries and in a variety of applications, and by users with a wide range of requirements. Returning
your transducer to Mensor for service benefits you in several ways:
• Our extensive knowledge of the transducer assures you that it will receive expert care.
• Repair or replacement of the CPT6030 transducers will be available up to 7 years after the production life cycle of the product,
pending external vendor parts or equivalent parts availability. The production life cycle is defined as the time from the product
series launch to the announcement of discontinuation (typically 8 to 10 years).
• All repairs should be performed by Mensor due to the complexity of performing these repairs.
6.2 Recalibration
The CPT6030 automatically calculates the pressure reading for all effects of temperature and non-linearity within the compensated
temperature range. This process is referred to as dynamic compensation because each reading is adjusted before it is output.
Thus, a calibrated CPT6030 operated within its temperature band, and with proper zero and span adjustments, will provide
accurate pressure measurements.
The CPT6030 should have the calibration verified periodically to ensure stability. The recommended calibration interval for this
instrument is given in the Specifications section under “Calibration Interval” in Section
8.1.
.
6.2.1 Calibration Services by Mensor or WIKA worldwide
Mensor and WIKA worldwide have extensive experience and knowledge of Mensor products. Calibration of the transducers can be
performed at the addresses below or by competent internal or external labs using the procedures in this section.
Service Center USA
Service Center Europe
Mensor
website: www.mensor.com
tel: 1-512-396-4200
1-800-984-4200
fax: 1-512-396-1820
email: [email protected]
WIKA Alexander Wiegand SE & Co. KG
website: www.wika.de / www.wika.com
tel: (+49) 9372 132-0
fax: (+49) 9372 132-406
email: [email protected]
Service Center China
WIKA China
website: www.wika.cn
contact: Eric Wang
tel: (+86) 512 6878 8000
fax: (+86) 512 6809 2321
email: [email protected]
