Wieland wienet v3, Руководство пользователя

Страница: 76 / 95

Contents of Package
77
Wieland Electric GmbH | BA001039 (Rev. A) | 08/2016
5.24 Automatic Update Configuration
In the
Automatic update
item it is possible to set the automatic configuration update. This choice enables
the router to download the configuration and the newest firmware from the server automatically. The
configuration and firmware files are stored on the server. To prevent possible unwanted manipulation of
the files, downloaded file (tar.gz format) is controlled. At first, the format of the downloaded file is
checked. Then the type of architecture and each file in the archive (tar.gz file) is controlled.
By
Enable automatic update of configuration
it is possible to enable automatic configuration update.
By
Enable automatic update of firmware
it is possible to enable firmware update.
Item Description
Source Where the router will download the firmware and configuration from:
•
HTTP(S)/FTP(S) server – updates are downloaded from the Base URL ad-
dress below. Used protocol is specified by that address: HTTP, HTTPS, FTP
or FTPS.
•
USB flash drive – Router finds current firmware or configuration in the
root directory of the connected USB device.
•
Both – looking for the current firmware or configuration from both
sources.
Base URL Enter the base part of the domain or IP address to download the updates
from. Specify the communication protocol by the address (HTTP, HTTPS, FTP
or FTPS).
Unit ID Name of configuration (name of the file without extension). If the Unit ID is
not filled, the MAC address of the router is used as the filename (the delimiter
colon is used instead of a dot.)
Update Hour Use this item to set the hour (range 1-24) when the automatic update
will be performed every day. If the time is not specified, automatic update is
performed five minutes after turning on the router and then every 24 hours. If
the detected configuration file is different from the running one, it is down-
loaded and the router is restarted automatically to make it run.
Note!
The
configuration file
name consists of
Base URL
, hardware MAC address of ETH0 interface
and cfg extension. Hardware MAC
address
and
cfg
extension is connected automatically
and it isn’t needed to enter this. By parameter
Unit ID
enabled it defines the concrete con-
figuration name which will be download to the router. When using parameter
Unit ID
, hard-
ware MAC address in configuration name will not be used.
The
firmware file
name consists of the
Base URL
, the type of the router and the bin
extension.
Attention!
It is necessary to load both files (.bin and .ver) to the HTTP(S)/FTP(S) server. If only the bin
file is uploaded and the HTTP server sends the incorrect answer of
200 OK
(instead of expected
404 Not Found
) when the device tries to download the
nonexistent .ver file, then there is a risk that the router will download the
.bin file over and over again.
NOTE
ATTENTION