Wieland wienet v3, Руководство пользователя

Страница: 65 / 95

Contents of Package
Wieland Electric GmbH | BA001039 (Rev. A) | 08/2016
66
5.19.1 Sending SMS
After establishing connection with the router via serial interface or Ethernet, it is possible to use AT com-
mands for work with SMS messages.
Note!
The following table lists the commands that are supported by wieland routers. For other AT
commands
OK
response is always sent. There is no support for complex AT commands, in
such a case
ERROR
response is sent by router.
AT Command Description
AT+CGMI Returns the manufacturer specific identity
AT+CGMM Returns the manufacturer specific model identity
AT+CGMR Returns the manufacturer specific model revision identity
AT+CGPADDR Displays the IP address of the ppp0 interface
AT+CGSN Returns the product serial number
AT+CIMI Returns the International Mobile Subscriber Identity number (IMSI)
AT+CMGD Deletes a message from the location
AT+CMGF Sets the presentation format of short messages
AT+CMGL Lists messages of a certain status from a message storage area
AT+CMGR Reads a message from a message storage area
AT+CMGS Sends a short message from the device to entered tel. number
AT+CMGW Writes a short message to SIM storage
AT+CMSS Sends a message from SIM storage location value
AT+COPS? Identifies the available mobile networks
AT+CPIN Is used to query and enter a PIN code
AT+CPMS Selects SMS memory storage types, to be used for short message operations
AT+CREG Displays network registration status
AT+CSCA Sets the short message service centre (SMSC) number
AT+CSCS Selects the character set
AT+CSQ Returns the signal strength of the registered network
AT+GMI Returns the manufacturer specific identity
AT+GMM Returns the manufacturer specific model identity
AT+GMR Returns the manufacturer specific model revision identity
AT+GSN Returns the product serial number
ATE Determines whether or not the device echoes characters
ATI Transmits the manufacturer specific information about the device
List of AT commands
Example 1: SMS sending configuration.
After powering up the router, an SMS is sent to the defined phone number in the following format:
Router (Unit ID) has been powered up. Signal strength –xx dBm.
After connect to mobile network, an SMS is sent to the defined phone number in the following format:
Router (Unit ID) has established connection to mobile network. IP address xxx.xxx.xxx.xxx
After disconnect to mobile network, an SMS is sent to the defined phone number in the following format:
Router (Unit ID) has lost connection to mobile network. IP address xxx.xxx.xxx.xxx
NOTE