Wieland 83.041.0869.1, Руководство пользователя

Страница: 14 / 26

5 | Router Design
Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016
15
5.8.3 Antenna connector WiFi
If the router is equipped with a WiFi module on the customer’s request, an appropriate antenna is con-
nected to the reverse SMA connector (WiFi).
The external antenna is connected by screwing this antenna to the reverse SMA connector on the front
panel of the router (see figure below).
5.8.4 MicroSD card reader
The microSD card reader is placed on the rear panel of the router (there is only a single slot). This card
reader allows the router to operate with memory cards microSD. Technical specifications are stated in
the table below:
Technical specifications of microSD card
Supported technologies
SDHC, SDXC
Supported capacity SDHC
SDXC up to 32 GB
from 32 GB to 64 GB
Supported microSD card filesystems vfat, ext2, ext3, ext4
Changing the microSD card:
•
Use the flat end of a spudger, or your fingernail, to press the microSD card slightly deeper into its slot
until you hear a click.
•
After the click, release the card and it will pop out of its slot.
•
Remove the microSD card and push any other microSD card into the slot until it clicks in place.
SD card