5
| Router Design
14
Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016
5.8.1
Status indication
Router status is shown by nine LED indicators on the front panel. Each ETH port has two additional
LEDs that provide information about theport status
.
Caption
Color
State
Description
PWR
Green
Blinking
On
Fast blinking
Router is ready
Starting of the router
Updating firmware
USR
Yellow
—
Function of this LED diode can be selected by user
IN0
Green
On
Binary input no. 0 is active
IN1
Green
On
Binary input no. 1 is active
OUT
Yellow
On
Binary output is active
ETH0
ETH1
ETH2
Green
On
Off
Selected 100 Mbit/s
Selected 10 Mbit/s
ETH0
ETH1
ETH2
Yellow
On
Blinking
Off
The network cable is connected
Data transmission
The network cable is not connected
Attention!
State indication of WAN LED is updated every 10 seconds.
5.8.2
Power connector PWR
Panel socket 2-pin.
Pin number
Signal mark
Description
1
GND(-)
Negative pole of DC supply voltage
2
VCC(+)
Positive pole of DC supply voltage (+10 to +60 V DC
Power connector
Power supply for router must be b10 V to +60 V DC supply. Protection against reversed polarity
without signaling is built into the router.
wienet
WR-LAN v3 SL
can be put into "low power mode" using a special command. Then it can be
awakened for example by an activity on binary input or using an internal timer.
Circuit example:
Connection of power supply
ATTENTION
Содержание 83.041.0869.1
Страница 26: ......
