Installing a router in a metal housing
Wieland Electric GmbH | BA000917 | 08/2021 (Rev. C)
39
10
INSTALLING A ROUTER IN A METAL HOUSING
ESD component
Observe precautions for handling electro sensitive devices!
Expansion port PORT1 and PORT2 can be connected only when the router is switched off.
Figure 39: Router in metal housing
1 Router's motherboard B-RB-v2
2 Expansion port PORT1
3 Expansion port PORT2
4 Left sidewall
5 Right sidewall
6 Rear panel
7 Front panel
8 Bottom cover
9 Top cover
10 Spacers (6×)
11 Screws (8×)
Unscrew the four screws (pos. 11) on the rear panel (pos. 6) and remove it.
Take out the router's motherboard B-RB-v2 (pos. 1).
Connect the expansion port PORT1 (pos. 2) to the connector J8 (see figure above) on the rout-
er's motherboard B-RB-v2 (pos. 1) from the top.
Connect the expansion port PORT2 (pos. 3) to the connector J3 (see figure above) on the rout-
er's motherboard B-RB-v2 (pos. 1) from the top.
Attach each expansion port to the motherboard with three spacers for each (pos. 10).
CAUTION
CAUTION
