Snow Master Vario Flex 3370
8 Before Initial Operation
02 | 2019
3370 99 01 – 003
41
8.2.2.
Using the separator plates
If required, the separator plates can be removed – with the outer
shield folded in – in order to get closer to an obstacle with the
inner shield.
8.2.3.
Adjusting the distance between the middle and outer
shields
Regularly check whether the distance (1) between the
middle and outer shields remains constantly approx. 6
mm from top to bottom.
Adjust the distance between the middle and outer
shields as required by turning the adjusting bolt (2).
Turn the cylinder eyelet (3) on the piston rod (4) until
the outer shield presses against the adjusting bolt (2)
when extended. To do so:
Undo the lock nut (5) on the piston rod (4) and turn
the cylinder eyelet and piston rod (3) in or out
accordingly.
Secure the cylinder eyelet (3) with the lock nut (5)
again.
INFO!
If the piston rod is not pushing the outer shield
against the adjusting screw, during operation
this could result in uneven movement of the
outer shield (wobbling).
