Weldmatic 350 & 500 | Operator Manual | Model No CP144-2/CP145-2
17
16
10-
Fig 4b Gas Shielded Solid Wires
Fig 4c Gasless Flux Cored Wires
Fig 4a Wire Stickout for Gasless Welding
Gun Position
For “down hand” fillet welding with gas
shielded solid wires, the gun is normally
positioned as shown in Figure 4a below,
with the nozzle end pointing in the direction
of travel.
For “down hand” fillet welding with gasless
flux cored wires, the gun is normally
positioned as shown in Figure 4b, with the
nozzle end pointing away from the direction
of travel, referred to as ‘dragging’ the
weld. Gasless flux cored wires should be
operated with approximately 10-15mm of
wire ‘stick-out’ from the welding contact tip
as shown in Figure 4c.
Содержание CP144-1
Страница 35: ...35 NOTES ...
