Washing
Machine
(1)
Detergent Box
Manual
(1)
Packing Instructions
Drain Hose
Assembly
(1)
Water Inlet
Hose Assemb
l
y
1
Parts Names
Rat Guar
d
(1)
Screw
(1)
Warranty
Car
d
1
EJ
Faucet
,....., __ Power Cord
Plug
\L----- Power
Cord
�\
--/���\----- Pre-wash
Operation
Panel
Washing/Spin
drying Drum
(This diagram is for reference
only. The actual product shall prevail.)
5
Adjustable
Foot (1)
Switch
Panel
Frame
Pulsator
Installation Instructions
Shield Installation
1.Take out the Shield on the Panel Frame protective
packaging and the Screws in the bag.
2.Tilt the Washing Machine backward and slowly put it
down on a cushion.
3.Push the Shield straight along the Seat Slot until it is
installed in place.
4.Fix the Shield and Seat with Screws.
5.Lift the Washing Machine gently until it is placed
steadily.
•---------------------------------------
Placement of the Washing Machine
Shie
ld
Screw
1.Choose a dry place without direct sunlight to the Washing Machine.
Bottom Bracket
2.Place the Washing Machine on steady solid ground. ,--------.---------.
3.A floor drainer shall be provided in the place where
Q
�
:
X
�
the Washing Machine is placed, and shall drain water
':, 2
:
"'
1
t
"
smoothly. The floor drainer shall be in the same plane
'--"'
:
o·
Q
as that where the Washing Machine is placed or slightly
Ti
l
le
d
Groun
d
lower than the plane, to avoid Washing Machine
ste��
l
�
d
cfr��n
d
:
leakage causing any damage.
-
X
- - - -
a
- - -
�
- - - - -
:
- -
X
- - - -
a
- - -
;
- - - -
4.Place the Washing Machine as firmly as possible.
§-��
:
�"'��
If necessary, level the Washing Machine by
•
,
,.
adjusting the Adjustable Feet of the Washing
-
:
-
Machine according to the order shown in the figures.
:
The maximum allowable inclination of the plane on
Unstea
d
y Groun
d
:
which the Washing Machine is placed is 2
°
.
- - - - - - - - - - - - - -•
Support Stan
d
an
d
Platform
Notes:
Bottom Bracket
Bottom Bracket
•When the Washing Machine is placed on the floor
or a flexible support stand, the Washing Machine
may vibrate.
•Do not place any object such as a carpet below the
Washing Machine to prevent the bottom opening
from being blocked.
•----------------------------------------
Faucet Selection
Faucet Type: (the faucet mouth shall be
smooth)
Type A: The most appropriate
Type B: Faucet length must be greater
than 16mm. Otherwise the universal joint
cannot be installed.
Type C: Water leakage may occur with
the part shown in the figure.
•----------------------------------------
Notes:
�·�
A
d
justab
l
e Foot
A
d
justab
l
e Foot
""b, :�:�
�: �e: :::�(\:���i•mayocm
- - - - - - -
-·-
- - - - - - -
-·-
- - - - - - - - - -
•If you
d
o not use the appropriate faucet,
please replace it.
1.When installing the Washing Machine, please be sure to remove the Pedestal and Bracket
for transportation at the bottom of the Washing Machine. Otherwise it cannot be used.
2.During installation or initial use, a small amount of water will flow out of the Drain Hose,
which is residual water left over from the factory during routine inspection.
3. Unplug the Power Cord when Washing Machine is not in use and turn off the faucet to
avoid accidental fires and water leakage accidents.
6
