background image

Whirlpool is a registered trademark of Whirlpool USA

5019 396 01115

Before using the dishwasher, read the 

installation and maintenance instructions carefully!

1

GB

WP 80

1)

Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to different loads, 
extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness and power supply voltage.

2)

Energy label programme in compliance with EN 50242. - Information for Test Laboratories: for more detailed information on the 
EN comparison test and other tests, contact the following address: “[email protected]”.

3)

The antibacterial action has been shown in collaboration with the Pasteur Institute, Lille (France), in conformity with. Standard NF EN 13697 
- November 2001.

1. OVERVIEW

ON button

OFF button

Programme selection button
Press button P (repeatedly) until the required programme number 
appears on the display.
Fault indication and wash time display
In normal operation it indicates the remaining time (h:mm), 
whereas with “Delayed start” selected it indicates the time 
remaining until programme start (hh).
In the presence of a fault indication “F..” –, consult the section “5. 
What to do if …”.
Rinse aid level indicator and salt level indicator
They light up when rinse aid or salt need to be added. 
Add just before starting a wash cycle.

Set the detergent
Press button P (repeatedly) to set the type of detergent used.

This deactivates the rinse aid and/or salt indicator.
Half Load/Multizone button
Load the top or bottom rack only.
Press once = wash top rack (the indicator/symbol lights up)
Press twice = wash bottom rack (the indicator/symbol lights up)
Press 3 times = Off (Half load/Multizone deactivated).
When washing without the top rack, press the “Half load” (i.e. “wash 
bottom rack”) button. “twice (the corresponding indicator/symbol 
lights up).

Powder, gel, tablets (standard):

indicator off

Detergent with rinse aid:

left indicator

Detergent with salt + rinse aid:

right indicator

Power Clean
High pressure with an additional jet for better washing results and 
greater bottom rack load flexibility.
“Delayed start” button
Press the button (repeatedly) to delay the start of the programme. 
Adjustable from 1 to 24 hours. With each press of the button, the 
delayed start indicator increases by one hour and after 24 restarts 
from 00. Then press the START button. The dishwasher will start 
after the set time.
START button
The indicator lights up during operation, flashes when a fault 
occurs, and goes off at the end of the programme.
RESET button - for programme change or indication of faults
Press this button to cancel a started programme and selected 
extra functions. Press this button to cancel the main fault 
indicators (F..); also refer to the section “5. What to do if...”. The 
programme can then be selected and started.
Running programme indicator
A LED light projected on the floor indicates that the dishwasher is 
working.

Table 1.1.

Table of programmes

Detergent 

dispenser

Consumption

1)

P

Programmes

Available

options

Loading instructions

large small Litres

kWh

Minutes

1

40-70°C

Normally or heavily soiled 
crockery, including pots and 
pans.

X

X

7-17

0.99-1.75 65-220 ±

1)

2

Pre-Rinse

cold

Crockery to be washed later.

4.0

0.03

14 ±

1)

3

Glasses

40°C

Light soiling, for example 
glasses and cups.

X

10.0

0.85

100 ±

1)

4

Quickwash

40°C

Lightly soiled crockery, without 
dry residuals.

X

10.0

0.65

30 ±

1)

5

Eco

2)

50°C

Normally soiled crockery. 
Energy-saving programme.

X

X

11.0

1.05

155 ±

1)

6

Hy

3)

Normally or heavily soiled 
crockery, with additional 
antibacterial action. An 
interruption of the programme 
(e.g. due to door opening) can 
compromise elimination of germs.

X

X

13.0

1.50

115 ±

1)

7

Nightrinse

55°C

Normally soiled crockery, 
gentle and quiet (39 dbA) 
thanks to the lower pressure 
jet.

X

X

13.0

1.20

290 ±

1)

Содержание WP 80









Отзывы: