13
17.
Power cord—reinstall terminal box
cover and wires
Terminal
box cover
Place wires inside terminal box. Replace the cover by inserting
the hooks of the terminal cover into the slots in the floor of the
terminal box and sliding the cover tight against the back wall
where wires come in. Make sure wires are tucked inside the box
and not pinched by the cover.
NOTE:
Route power cord out the bottom rear channel provided.
Do not plug cord into an outlet until instructed to do so.
UTILITY ROUTING CHANNEL LOCATION
18.
Water supply hose, power cord
channel routing locations
Route water supply hose
and electrical supply through
the channels in the bottom
of base as shown.
Fill valve
Junction box
Electrical cord
Hose
Channels
Route the water supply and electrical supply to the back of the
unit through the bottom base channels provided. Secure utilities
in channel using tape or wire ties.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
19.
Stand dishwasher upright
Using two or more people, stand the dishwasher up.
NOTE:
Do not install kick plate until instructed to do so.
Dishwasher may fit tightly into cabinet opening. Do not remove
insulation blanket—the blanket reduces the sound level.
NOTE:
Route water supply, drain hose, and power cord out the
rear of the dishwasher.
20.
Move dishwasher close
to cabinet opening
Route the utilities through the holes in the cabinet, and pull
the slack out at the same time as the dishwasher is pushed into
the cabinet
21.
Route power cord
If using a power cord, make sure to route the end through hole
in cutout before sliding dishwasher into the cabinet opening.
Water
line
Drain
Cable
