Страница 1: ...gas supply line to the unit location We suggest using a 74 rigid pipe as smaller size pipe on long runs may result In the gas supply not being sufficient Pipe lolnt compounds resistant to the action of LP gas must be used The supply line should be equipped with a shutoff valve This valve should always be located in the same room as the range and should be in a locatron that allows ease of opening ...
Страница 2: ...op of the regulator either NAT or LPI To change the regulator setting Remove the aluminum hex nut plug with a wrench or coin Turn the hex nut or plug over and screw It back Into the regulator Caution Do not over tighten If the unit IS to be used on a NATURAL gas NAT should be vlslble on the regulator plug If the unit is to be used on LP gas LP should be visible on the regulator plug OBSERVE ALL GO...
Страница 3: ...of cut out in the cabinet b Anchor unit In cabinet with four special screws which are shipped with the unit NOTE The screws may be slanted slightly to catch wood cabinet on each side of cabinet cutout 1 3 Connect the gas supply line 4 Plug the range power supply cord into the grounded re ceptacle 5 Check for gas leaks with soapy water When the unit IS connected and all gas valves have been closed ...
Страница 4: ...ch standard IS not applicable with local codes GAS ADJUSTMENTS Refer to Use and Care Guide for lighting oven pllot and for correct size of oven burner flame Correctly adlusted oven pilot IS shown below Adlust the burner air shutters to the widest opening that will not cause the flame to lift or blow off of the burner WIRING DIAGRAM LOCATION Wlrlng diagrams are located Inside the control compart me...
