5
Tones
Tones are audible signals, indicating the following:
One tone
■
Valid pad press
■
Oven is preheated
■
Function has been entered
Three tones
■
Invalid pad press
Four tones
■
End of cycle
■
Reminder, repeating each minute after the end-of-cycle tones
Tone Volume
The volume is preset at high, but can be changed to low.
To Change: Press and hold the number pad 7 for 5 seconds. On
some models, a tone will sound and “Snd Lo” will appear on the
oven display for 3 seconds. If “Snd Lo” remains on the display,
press OFF/CANCEL to remove. Repeat to change back to “Snd
HI.”
All Tones (double oven models)
All of the above tones are preset on, but can be turned off.
To Turn Off/On: Press and hold STOP TIME for 5 seconds. On
some models, a tone will sound and “Snd Lo” will appear on the
oven display for 3 seconds. If “Snd Lo” remains on the display,
press OFF/CANCEL to clear. Repeat to change back to “Snd HI.”
Pad Press Tones (single oven models)
The single tones signaling a valid pad press are preset on, but
can be turned off.
To Turn Off/On: Press and hold STOP TIME for 5 seconds. On
some models, a tone will sound and “Snd off” will appear on the
oven display for 3 seconds. If “Snd off” remains on the display,
press CANCEL/OFF to clear. Repeat to change back to “Snd on.”
End-of-Cycle and Reminder Tones
The Timer and Timed Cooking end-of-cycle and reminder tones
are preset on, but can be turned off. On some models, if all tones
have been turned off, the end-of-cycle and reminder tones
cannot be independently turned on.
To Turn Tones Off/On: Depending on your model, press and
hold COOK TIME until a tone sounds and the oven display
returns to inactive mode (blank). If “EOC OFF” appears on your
display, press OFF/CANCEL to clear. Repeat to turn back on.
Reminder Tones Only
The Minute Timer and Timed Cooking reminder tones are preset
on, but can be turned off. However, on double oven models, if all
tones have been turned off, the reminder tones cannot be
independently turned on.
To Turn Tones Off/On: Press and hold TIMER SET until a tone
sounds. On some models, the oven display will display “NA9
OFF.” To remove this from the display, press OFF/CANCEL.
Repeat to turn back on.
Fahrenheit and Celsius
The temperature is preset in Fahrenheit; however, it can be
changed to Celsius.
To Change: Press and hold BROIL for 5 seconds. Depending on
your model, a tone will sound and “C°” or “C” will appear on the
display for 3 seconds, or until you press CANCEL. Repeat to
change back to Fahrenheit.
When in Fahrenheit, “°F” follows the oven temperature.
When in Celsius, only “°” follows the oven temperature.
Timer
The Timer can be set in minutes and seconds or hours and
minutes and counts down the set time. It does not start or stop
the oven.
To Set:
1. Press TIMER SET.
Press again to switch between MIN/SEC and HR/MIN.
If no action is taken within a certain amount of time (between
1 minute and 4 minutes depending on your model), the
display will return to the time of day mode.
2. Press the number pads to set the length of time.
3. Press TIMER SET.
If pad is not pressed within a certain amount of time (between
5 seconds and 4 minutes depending on your model), the
display will return to the time of day mode and the
programmed function will be canceled.
When the set time ends, if enabled, end-of-cycle tones will
sound, then reminder tones will sound every minute.
4. Press TIMER OFF anytime to cancel the Timer or stop the
reminder tones.
If OFF/CANCEL is pressed, the respective oven will turn off.
The time can be reset during countdown by repeating the
above steps.
Control Lock
The Control Lock shuts down the control panel pads to avoid
unintended use of the oven(s). The Control Lock will remain set
after a power failure, if set before the power failure. The only time
it is not available is during the Sabbath Mode or Self-Clean cycle.
When the control is locked, the TIMER SET, TIMER OFF, OVEN
LIGHT and OFF/CANCEL pads will function. On double oven
models, CLOCK SET will also function.
The Control Lock is preset unlocked, but can be locked.
To Lock/Unlock Control: Press and hold the number pad 3
CONTROL LOCK for about 5 seconds until “CONTROL LOCK”
and a picture of a lock appear on the display. Repeat to unlock
and remove “CONTROL LOCK” from the display.
Oven Temperature Control
IMPORTANT: Do not use a thermometer to measure oven
temperature because opening the oven door and element or
burner cycling may give incorrect readings.
The oven(s) provide accurate temperatures; however, they may
cook faster or slower than your previous oven, so the
temperature calibration can be adjusted. It can be changed in
Fahrenheit or Celsius.
