8
program will be reset. To start again, press
.
At the end of the program, the cycle symbol
lights up
orange and the temperatures of the tank (L) and boiler (R)
appear on the display. In the versions with CVC (steam
recovery), once the rinse cycle ends, the steam suction
phase begins, which lasts 25 seconds. The warning: “Do
not open, energy recovery” will appear on the display.
Upon completion, the cycle symbol
lights up orange
and the temperatures of the tank (L) and boiler (R) appear
on the display. If you open the hood before the end of the
energy recovery phase, the optimum performances of the
CVC will not be guaranteed.
Unload the basket
NB : if the machine is not used for more than 20’, the ECONOMY phase is activated to save electricity.
Automatic regeneration cycle
The regeneration cycle is automatic and is activated after
83 wash cycles, which are set in the installation phase
and which can be changed by the installer. When the
letter –R – blinks in the bottom right part of the display, it
means that the regeneration cycle will start once the
machine is switched off.
Once the machine is switched off, the overflow device
has been removed and the discharge phase has started
(consult DISCHARGE section), the regeneration cycle will
start automatically and will last 20 minutes. Once the
cycle ends, the machine will stop in stand-by OFF mode:
Open the door/hood, put the filters and overflow device
back in place in the tank. Switch the main on/off switch off
on the wall and shut-off the mains water tap.
The word “SALT” will appear if salt is missing.
Attention: use exclusively specific salt for dishwashers and not kitchen salt.
The salt compartment takes approximately
1 kg of grain salt
.
The salt compartment is located on the bottom of the tank. Take the basket out, unscrew the cap and pour salt
in using a funnel (not supplied). Before screwing the cap back on, remove any spilled salt near the opening.
Top-up with salt
when there is no water in the tank
so that the washing water cannot get into the water
conditioning device; always unplug the machine from the mains power supply before doing this operation.
Remember to plug the machine back into the mains socket after completing the operation.
When using the machine for the first time, after you fill with salt, add some water to the salt container.
No other operation can be carried out while the regeneration cycle is running.
