GB -1-
Whirpool is a registered trademark of Whirpool USA
Chart
5019 396 03664
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to
be refilled.
SALT INDICATOR
When lit (at the end of the cycle), the
salt reservoir needs to be refilled.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected
it indicates the time remaining until program start (h.00) - below 1h (0:min).
If “Fx Ey” messages appears on the display, see page 9 - chapter “What to do if...”.
PROGRAM
SELECTION
BUTTON
Push “P” button
(repeatedly) until selected
program number is shown
on the display (P1...Px) -
see “Table of programs” -
next page).
MULTIZONE
Allows you to choose the
washing zones. Press this
button (repeatedly) to
select the wash zones:
both racks
only lower rack
only upper rack
(including
cutlery rack)
- indicator lits
DELAYED START
BUTTON
Push the button
(repeatedly) to delay the
start of the program.
Adjustable from 1 to 24
hours. With each press of
the button, the delayed
start indicator increases
by one hour and after
24 restarts from 0. Then
press the START button.
The dishwasher will start
after the set time.
POWER CLEAN
Thanks to the additional
power jets this option
provides a more intensive
and powerful wash in the
lower rack, in the specific
area. This option is
recommended for
washing pots and
casseroles (see page 7).
Press this button to
activate Power Clean
(the indicator lights up).
For non Power Clean
loading to achieve best
cleaning performances
and resources
optimization, Power
Clean should be switched
off.
TABLET SETTING
This setting allows to
optimize the cycle
performances according
the type of detergent
used. Push the Tablet
button for 3 seconds (until
the indicator lights up)
if you are using the
combined detergents in
tablet (rinse aid, salt and
deteregent in 1 dose).
If you are using powder
detergent or liquid
detergent, the Tablet
indicator on the control
panel has to be off.
START/RESUME
BUTTON
Push this button to start
the selected program: the
indicator lights up and
goes off at the end of the
program.
When the door is opened
during a washing cycle, the
cycle is temporarily
paused: the Start indicator
blinks.
To resume the cycle close
the door and push Start
button again.
CANCEL/OFF
BUTTON
Push this button to switch
off the control panel.
If pressed when a
program is running it
cancels the program
ongoing draining water for
1 minute (0:01 is shown
into the display).
If pressed when the
dishwasher is switched
off, it drains any possible
liquids from dishwasher
(1 minute process).
Quick reference guide
