GB -1-
Chart
(see at right for options description)
PROGRAM SELECTION
BUTTON
Push “P” button (repeatedly)
until selected program number
is shown on the display
(P1...Px) - see “Table of
programs” below.
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program.
When the door is opened during a washing cycle,
the cycle is temporarily paused: the Start indicator
blinks. To resume the cycle close the door and
push Start button again.
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute
(0:01 is shown into the display).
If pressed when the dishwasher is switched off,
it drains any possible liquids from dishwasher
(1 minute process).
1)
Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may vary depending on
conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.
2)
Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the
EN/Standard loading comparison test and other tests, contact the following address: “[email protected]”.
3)
The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.
Table of programs
Deter-
gent
Consumption
Drying
Phase
Programs
Available
options
Loading instructions
Litres
kWh
Minutes
1)
P1
Sensor
40°-70°C
Delay
Power Clean
Recommended program for routine
washes, with dried-on food (e.g. EN
50242).
X
7-14 1.00-1.60
70-155
Full
P2
Pre-Wash
cold
Delay
Crockery to be washed later.
—
4.0
0.03
14
NO
P3
Fragile
40°C
Delay
Light soiling, for example glasses and
cups.
X
10.0
0.85
100
Light
P4
Rapid
45°C
Delay
Lightly soiled crockery, with no dried-
on food.
X
11.0
0.80
30
NO
P5
Eco
2)
50°C
Delay
Power Clean
Normally soiled crockery.
Energy-saving program.
X
11.0
1.03
150
Full
P6
Fast Daily
60°C
Delay
Normally soiled crockery.
X
10.0
1.30
80
Full
P7
Steam
Delay
Power Clean
Program including steam action
dedicated for heavily soiled crockery,
pots and pans. Soaking or hand
pretreatment is no longer needed.
X
14.0
1.70
180
Full
P8
Hygiene
3)
Delay
Power Clean
Normally or heavily soiled crockery, with
additional antibacterial wash. Program
interruption (e.g. due to door opening)
can compromise elimination of germs.
X
13.0
1.50
118
Full
5019 396 03653
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS
QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
Options and display description
SALT INDICATOR
When lit (at the end of the cycle),
the salt reservoir needs to be
refilled.
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to
be refilled.
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY
BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
TABLET SETTING
This setting allows to optimize
the cycle performances
according the type of
detergent used. Push the
Tablet button for 3 seconds
(until the indicator lights up) if
you are using the combined
detergents in tablet (rinse aid,
salt and detergent in 1 dose). If
you are using powder
detergent or liquid detergent,
the Tablet indicator on the
control panel has to be off.
POWER CLEAN
Thanks to the additional
power jets this option
provides a more intensive
and powerful wash in the
lower rack, in the specific
area. This option is
recommended for washing
pots and casseroles (see
page 4). Press this button to
activate Power Clean (the
indicator lights up).
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates
the time remaining until program start (h.00) - below 1h (0:min).
If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.
DELAYED START BUTTON
Push the button (repeatedly) to
delay the start of the program –
delay indicator turns on.
Adjustable from 1 to 24 hours.
With each press of the button,
the delay increases by one hour
and after "h 24” returns to
"h 00”. When this option is
selected the delay indicator
turns on. Then press the
START button. The dishwasher
will start after the set time.
Quick reference guide
Whirlpool is a registered trade mark of Whirlpool USA
