background image

GB -1-

Chart

(see at right for options description)

PROGRAM SELECTION 

BUTTON

Push “P” button (repeatedly) 

until selected program number 

is shown on the display 

(P1...Px) - see “Table of 

programs” below.

START/RESUME BUTTON

Push this button to start the selected program: the 

indicator lights up and goes off at the end of the program. 

When the door is opened during a washing cycle, the 

cycle is temporarily paused: the Start indicator blinks. 

To resume the cycle push Start button and close 

the door within 3 seconds.

CANCEL/OFF BUTTON

Push this button to switch off the control panel.

If pressed when a program is running it cancels the 

program ongoing draining water for 1 minute 

(0:01 is shown into the display).

If pressed when the dishwasher is switched off, 

it drains any possible liquids from dishwasher 

(1 minute process).

1)

Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may 

vary depending on conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic 

calibration system.

2)

Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard 

loading comparison test and other tests, contact the following address: “[email protected]”.

Table of programs

Deter-

gent

Consumption

Drying

Phase

Programs

Available

options

Loading instructions

Litres

kWh

Minutes

1)

P1

Sensor

40-70°C

Delay

Power Clean

Recommended program for routine 

washes, with dried-on food 

(e.g. EN 50242).

X

7-14

1.00-1.60

70-155

Full

P2

Pre-Wash

cold

Delay

Crockery to be washed later.

4.0

0.03

14

NO

P3

Fragile

40°C

Delay

Light soiling, for example glasses and 

cups.

X

10.0

0.85

100

Light

P4

Rapid

45°C

Delay

Lightly soiled crockery, with no 

dried-on food.

X

11.0

0.80

30

NO

P5

Eco

2)

50°C

Delay

Power Clean

Normally soiled crockery. 

Energy-saving program.

X

11.5

1.03

170

Full

P6

Fast Daily

60°C

Delay

Normally soiled crockery. 

X

10.0

1.30

80

Full

P7

Half Load

50°C

Delay

Ideal for washing a half load of lightly 

or normally soiled crockery.

X

10.0

1.07

132

Full

P8

Intensive

65°C

Delay

Power Clean

Recommended program for heavily 

soiled crockery, especially suitable 

for pans and saucepans.

X

14.0

1.60

145

Full

5019 396 03637

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS 

QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

Options and display description

WASH TIME DISPLAY

Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates 

the time remaining until program start (h.00) - below 1h (0:min).

If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY 

BUTTON EXCEPT CANCEL/OFF BUTTON.

FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES 

AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.

POWER CLEAN

Thanks to the additional power jets this option provides a more 

intensive and powerful wash in the lower rack, in the specific 

area. This option is recommended for washing pots and 

casseroles (see page 4). Press this button to activate Power Clean 

(the indicator lights up).

TABLET SETTING

This setting allows to 

optimize the cycle 

performances according the 

type of detergent used.

Push the Tablet button for 

3 seconds (until the indicator 

lights up) if you are using the 

combined detergents in 

tablet (rinse aid, salt and 

detergent in 1 dose).

If you are using powder 

detergent or liquid 

detergent, the Tablet 

indicator on the control 

panel has to be off.

DELAYED START BUTTON

Push the button (repeatedly) 

to delay the start of the 

program. - delay indicator 

turns on. 

Adjustable from 1 to 24 hours. 

With each press of the button, 

the delayed increases by one 

hour and after “h 24” returns 

to “h 00”. 

When this option is selected 

the delay indicator turns on. 

Then press the START button. 

The dishwasher will start after 

the set time.

SALT INDICATOR

When lit (at the end of the cycle), 

the salt reservoir needs to be 

refilled.

RINSE AID INDICATOR

When lit (at the end of the cycle), 

the rinse aid dispenser needs to 

be refilled.

Quick reference guide

Whirpool is a registered trademark of Whirpool USA

Содержание ADG 7800/2









Отзывы: