Whirlpool 6ADP905/3 WH, Руководство по обслуживанию

Страница: 14 / 19

WHIRLPOOL CONSUMER SERVICES
Models 6ADP905/3 WH
Page 14 of 19
Failure Failure No. Indication Test Program Indication
NTC failure F1 Start LED flashes PS1 LED Flashes
Water leakage F2 Start LED flashes PS2 LED Flashes
Heating system F3 Start LED flashes PS3 LED Flashes
Drain system F4 Start LED flashes PS4 LED Flashes
Spray arm Blocked F5 Start LED flashes PS1 & PS4 Flash
Water inlet closed F6 Start LED flashes PS2 & PS4 LED’s Flash
Flow meter F7 Start LED flashes PS3 & PS4 LED’s Flash
Water level F8 Start LED flashes PS2 & PS3 LED’s Flash
Continuous water fill F9 Start LED flashes PS1 & PS3 LED’s Flash
Rinse aid low Red LED on Red LED on
NOTE: The machine will not store Fault Code F6 located during normal operation, only
during the active test. Therefore the active test MUST be run for the
diagnostics to locate this fault. All Other Fault codes located during normal
operation are stored by the machine and will be displayed by the passive test.
PASSIVE TEST PROGRAM
Passive test program will indicate the mode of
Start failure. If there is no failure, the test program
will result in PS1 to PS4 flashing sequentially.
Starting the Passive Test Program
PS1 - PS4 1. Turn the program selector to the off
Flash sequentially (“O”) position
2. Push and hold the start button while
turning the program selector to
first cycle (rinse) until the START LED
Chosen program begins to flash.
LED lights
3. Release the start button.
4. The LED’s, PS1 to PS4, will now
flash in sequence or light to indicate the
Finish passive test mode of failure of the dishwasher.
program by starting
active test program
5. Repair failure
6. Reset program by pressing start button
for more than 3 seconds
7. Start passive test again and progress to
active test by pressing the start button
for less than
3 seconds
Start
Program Selector
PS1 PS2 PS3 PS4
Wash Program Indicators
Rinse