BDA CS 300
– 06/15 – REV. B
Page 69 / 84
9
Normal Operation, Production Cycle
DANGER
+
Due to the risk of hand or finger injury, never try to reach into the electric Crimping Machine
CS 300 before having assured that the machine is disconnected from the power supply.
+
Disconnect the power supply by pressing the ON/OFF switch and by pulling out the main
plug before mounting or exchanging the adapter, tool head or die set.
CAUTION
+
Do not operate the electric Crimping Machine CS 300 before having read and understood
all operating instructions.
+
The operating instruction must be constantly within reach of the electric Crimping Machine
CS 300. Every machine operator must have read and understood this operating
instruction. The safety instructions, warnings and precautions contained in the individual
chapters must be strictly observed by all users and operators when working on or with the
electric Crimping Machine CS 300.
+
The electric Crimping Machine CS 300 may only be operated in a complete and functional
condition.
+
Before commissioning the machine, it is always important to check whether all safety
devices and a WEZAG approved adapter, tool head or die set is installed and is functioning
correctly.
+
The crimp machine is only allowed to be used with mounted adapter with tool head or tool
head with die set.
+
Assure free access to the operating elements of the electric Crimping Machine CS 300,
especially the foot pedal and the release button. In the case of imminent danger
immediately press the release button. The release button must be within the direct reach
of the operator. It must not be covered.
+
When working with the electric Crimping Machine CS 300, do not wear loose clothing,
jewellery or long, loose hair that can get caught in the mechanism.
+
Work with caution.
+
In cases of a machine malfunction, production must be stopped and the malfunction must
be fixed before continuing work with the electric Crimping Machine CS 300.
+
Only one person is allowed to work on or with the electric Crimping Machine CS 300.
+
Only trained personal are allowed to work on or with the electric Crimping Machine
CS 300.
ATTENTION
+
Position the electric Crimping Machine CS 300 on a flat surface and assure the stability of
the machine. Ensure that the table or bench is stable enough to support the machine in
normal use. During the utilization, the machine has to be placed on a table or a similar flat
surface.
+
Place the foot pedal on the floor. No other place is allowed. The foot pedal must be
movable, so that the operator has the possibility to change his position for ergonomic and
production needs.
+
Do not lay the foot pedal in aisles or walk ways.
+
Place the tubes on the floor so that they do not cause a trip hazard.
INFORMATION
+
To work fatigue-proof, the user has to take a working position where the machine is at the
right height and the foot pedal is accessible. The foot pedal has to be installed in a stable
position. The position of the foot pedal should be chosen in that way, that a free access
will be possible.
+
The noise level of the machine is max. 69 dB(A).
