Wexxar WF-10T, Руководство по эксплуатации и обслуживанию

Страница: 37 / 156

WF-10T Case Former Controls
5-25
5) ‘MAIN CONTROL’ Button
This button is located to the bottom left of the touchscreen when the
machine is in
JOG
mode. Pressing the
‘MAIN CONTROL’
button will
take the machine into
CYCLE
mode for regular operation.
In the bottom, left-center of the
‘Main Control’
screen is a
‘DRY
CYCLE ACTIVE’
machine status indicator. To the right of this
indicator in the bottom center of the machine is a
‘REMOTE DEMAND
ON’
status indicator. To the right of this indicator is a
‘BOX CALL
ACTIVE’
status indicator.
In the
CYCLE
mode, which is the default mode, the machine
automatically picks cases from the magazine and forms them without
any additional operator input.
Figure 5-7: Machine in AUTOMATIC CYCLE Mode
6) ‘START’ Button
The
‘START’
button starts the
CYCLE
of the machine to form cases
continually. If the
‘REMOTE DEMAND’
sensor is
ON
, automatic case
forming will stop when formed cases block the sensor on the outfeed
conveyor, and will resume when they move downstream away from the
sensor. Once pressed, the
‘START’
button will be replaced with a
‘STOP’
button.
NOTE: When the ‘START’ button is pushed, the ‘JOG CONTROL’
and ‘SETUP’ buttons disappear until the ‘STOP’ button is pushed
and the machine stops its cycle.
7) ‘STOP’ Button
The
‘STOP’
button stops the automatic machine cycle. If the
‘STOP’
button is pressed while the machine is in the middle of a case forming
cycle, the machine finishes forming the case in process and then halts
any further operation, returning the mechanisms to their
HOME
positions.
Figure 5-6: 'Main
Control' Button
Figure 5-8: ‘START’
Button
Figure 5-9: ‘STOP’
Button