User Guide
3. Component Overviews
3.8 Drive Assembly Description
Figure 31:
Overview Image
The cable management assembly (CMA) comes with an
optional
CMA tray that is used to support cable
loads greater than ten (five per arm). This tray is mounted at the bottom of the chassis using four M3 x 8mm
T10 Torx screws (two per side). Use this cable tray in cases where cables might interfere with the lower U
space beneath the chassis.
3.8
Drive Assembly Description
Figure 32:
Overview Image
The Drive Assembly is comprised of two parts: the storage drive and the drive carrier. The carrier attaches
to the exterior of the data storage drive and caddies the drive into the enclosure. It stabilizes the motion of
the drive into the drive bay so that the drive properly mounts onto the drive board.
54