Westermo Network Technologies
10
2.5.2
United States - FCC
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (i.) this device may not cause harmful interference and (ii.) this device must accept any
interference received, including interference that may cause undesired operation.
To satisfy FCC RF exposure requirements for mobile transmitting devices, a separation distance of 20
cm or more should be maintained between the antenna of this device and persons during operation.
To ensure compliance, operations at closer distances than this are not recommended.
This product has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This product generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
product does cause harmful interference to radio or television reception, which can be determined
by turning the product off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the unit and receiver
•
Connect the product into an outlet on a circuit different from that to which the receiver is
connected
•
Consult the dealer or an experienced radio/TV technician for help
NOTE
This product contains FCC ID XMR201901EM12G (LTE).
2.5.3
United States - AREMA
The product has been tested according to AREMA Part 11.5.1 and 11.5.2 environmental class I and
exposure class Internal.
2.5.4
Canada - IC
This device complies with Industry Canada’s license
-exempt RSSs. Operation is subject to the
following two conditions:
•
This device may not cause interference.
•
This device must accept any interference, including interference that may cause undesired
operation of the device.
