Start-up
The Radial Sweeper is equipped with a robust mechanism for reversing
the direction of rotation. The desired direction of rotation is set by means of
a hand lever, which can be easily reached from the normal working
position.
Fig. 14 - Determine the direction of sweeping
Pull the lever up to remove the retaining pin from the hole. Now swing the
lever into the desired position and then push the retaining pin into the provided
hole.
Since the power transmission from the engine to the brush element is via a V-
belt drive that requires some friction, you should press the direction selector
lever in the desired direction until there is a noticeable resistance (no force
necessary) and then fix it in the hole. Depending on the degree of wear of the
belt, it may be necessary after a certain period of use to fix the lever in the next
additional hole.
Before changing the direction of rotation, you should stop the brush by
moving the lever to the neutral position (see above in the middle) to avoid
unnecessary belt wear. Then position the lever again so that the brush
element turns in the desired direction.
Page
27
of
59
After each use, connect the WR 870 Battery to the charger
