WESTELL.COM
Remote RMM-700 Installation Guide
Installation
1-800-377-8766
Page 13
7. Run the lead wires through the clips on top of the two white plastic standoffs near
the module as shown in Figure 1-6. In the completed installation, the wires should
be clear of the circuit board.
Figure 1-6
Run the lead wires through the tops of the standoffs to keep them clear of
the circuit board.
8. Reinstall the Remote RMM-700 top cover, and reinsert and tighten the screws in
the top and back panels.
Step 2: Install Mounting Flanges
The Remote RMM-700 is designed for installation in a 19-inch or 23-inch equipment
rack using mounting flanges which attach to each side of the device. The Remote RMM-
700 also can be mounted onto a wall using the same mounting flanges.
Standoffs
