PS71090-P8 Product Manual
March 2018, Rev A
WESTELL.COM
©2017 Westell Technologies
March 2018; Doc No. CS14000802UM rA
1.877.844.4274
Page 29 of 52
5.7
Connecting to the Alarm Relay Panel
Use the provided Alarm Relay Serial Cable to connect the PS71090-P8 Public Safety Signal Booster to
the alarm relay panel. If the provided cable is not long enough for your system, you will need to build
one.
1.
Strip the outer serial cable insulation back to expose the inner conductors, Figure
5-3.
2.
Strip back the insulation on the ends of each conductor. (Tin wires as needed.)
Figure 5-3: Stripped Alarm Wire
3.
Remove the protective cover on the Alarm Relay 9 position D-Sub connector.
Figure 5-4: Alarm Relay 9 Position D-Sub Connector
