WesAudio PHOEBE, Руководство пользователя

Страница: 30 / 40

WESAUDIO
9/14/22
_PHOEBE USER MANUAL
30
6.8. Setup for mixing
The configuration of devices is plain & simple, and its management side follows Plug&Play principles,
so besides physical connection to your machine there are no other steps required.
6.8.1. HW insert/External effect in DAW
If you would like to work with WesAudio devices inside your DAW, audio signal must be sent to &
received from the HW unit. Below you can find steps which describe that process in detail.
To set up your environment two steps are necessary:
•
Device Control Setup:
o
Connect your workstation through USB cable and USB 2.0+ port (**) with your
hardware unit or _Titan rack frame.
o
Insert on your track WesAudio plugin which matches with your HW and select your
device from drop down list.
o
After connection state “ON” is light up, your device is ready to use, and saving your
session activity will store all the settings as they are.
•
Device Audio Setup:
o
Create any type of external effect which is supported in your DAW (e.g., “External effect”
in Cubase/Nuendo, “Hardware Insert” in Pro Tools).
o
Configure “Send” to WesAudio HW unit IN.
o
Configure “Return” to WesAudio HW unit OUT.
o
Connect all the wires from your audio interface to the unit IN/OUT.
o
Insert this effect after * WesAudio plugin in insert chain.
DAW
WesAudio
AAX/VST2/VST3/AU
HW
USB cable
I
N
Audio signal
O
U
T
Audio signal
Audio Interface
OUT
Audio Interface
IN