TRIPOD SYSTEM
USER INSTRUCTIONS
Page 9
ENGLISH
M
ULTIPLE
S
YSTEMS
Multiple systems may be attached to the Tripod; however, the Tripod is for a single
user only. A maximum of two systems may be attached to one Tripod, and a
maximum of one system may be attached to any one Tripod leg.
The Tripod System is designed for up to two users at one
time for emergency rescue applications only.
S
TEP
1: A
SSEMBLE
T
RIPOD
Place the Tripod on the fl oor with the feet on the ground. Remove the locking
pins from the head of the Tripod. Pull the legs away from the center and replace
the locking pins in head to secure the legs in the open position. Extend legs
to desired length and secure in place with locking pin. Place the Tripod over
the entry point. Adjust the Tripod as necessary by removing the leg pins so the
Tripod is level above the entry point. Remove excess slack in the safety chain by
adjusting the position of the carabiner.
Do not use the Tripod without the safety chain or without
safety chain properly adjusted.
S
TEP
2: A
TTACH
SRL-R M
OUNTING
B
RACKET
(T210030B,
T210060B, T210100B)
The mounting bracket attaches to the upper leg of the Tripod. Remove two locking
pins on the bottom of the mounting bracket and place on upper leg of the Tripod
orientated so the fl ange of the mounting bracket is on the external right. Insert
locking pins through holes on the bottom of the mounting bracket and through
upper leg of the tripod.
S
TEP
3: M
OUNT
3-W
AY
SRL-R
Loosen the large washer on the back of the 3-Way SRL-R with an allen wrench.
Orient 3-Way SRL-R so the cable is facing the top of the Tripod and the crank is
to the right. Mount 3-Way SRL-R to the right side of the mounting bracket fl ange.
Slide the large washer into the slot on the mounting bracket and tighten with allen
wrench. Insert hand screw through the swivel top of the 3-Way SRL-R through the
bottom of the mounting bracket and hand tighten.
WARNING!
WARNING!
