34
WiPG-1600W User’s Manual
7.5.4 WiFi Setup
< Wireless LAN>: You can choose to enable or disable the wireless LAN
(WiFi function). The default value is “Enable”. [If you disable the WiFi of the
WiPG-1600W, you need to connect the device to an existing IT network
through an Ethernet cable.]
< Mode>: Access Point (AP)/Station/AP & Station [the default value is AP].
< AP Mode >
SSID: You can change the default SSID [the maximum length is 32
bytes].
SSID Broadcast: The default value is “Enable”.
Band: “2.4 GHz” or “5 GHz” [The default value is “2.4 GHz”].
Channel: The default value is “Auto” (you can also choose to set a
fixed channel). The “Auto” option means that after the WiPG-1600W
device is powered on, the system will scan all the wireless channels
and select a clear channel automatically.
Encryption: The default value is “Disable” (you can also choose
“WEP”, “WPA PSK”, “WPA2 PSK”, “WPA Enterprise” or “WPA2
Enterprise” matching the AP’s setting).
Key: If the “Encryption” function is enabled, you have to set the “Key”
value according to the encryption mode you have selected. If the
length of the key entered is too short or long, a warning message
will pop up.
Channel Bandwidth: “20MHz” or “Auto” (20MHz/40MHz) [the default
value is “Auto”].
< Station Mode >
Connect to Existing AP: Click “Scan” and a list of available APs will be
shown. Select an AP from this list. If the AP you want to connect to is
not displayed in the list, please manually enter the SSID of the AP.
Encryption: If you manually enter the SSID of the AP, you need to
select the encryption type (WEP/WPA AES/WPA2 AES/ WPA TKIP/
WPA2 TKIP/802.1x EAP) matching the AP’s setting.
Key: If the “Encryption” function is enabled, you have to set the “Key”
value according to the encryption mode you have selected. If the
length of the key entered is too short or long, a warning message
