Wenglor ZAC5 EN0 Series, Руководство по эксплуатации

Страница: 30 / 40

30
EN
8.11. Vendor-specific object (0x64)
The vendor-specific object 100 is used for configuration of the I/O ports and PoE ports etc.
Vendorspecific Object (0x64)
Class Attributes
ID Name Access
Keine Class Instanz vorhanden. Attribute 1 nicht benötigt da Revision == 1
Class Services
Code Name
Keine Class Instanz vorhanden
Instance Attributes
ID Name Access Supported by
1 Direction Register (16 bit) (see below) Get/Set all Switches
2 Power Monitoring (BOOL) (see below) Get/Set not ZAC51EN01
3 PoE Enable (8 bit) (see below) Get/Set not ZAC51EN01
4 WebServer Access (BOOL), 0= disable, 1=enable Get/Set all Switches
Instance Services
Code Name
0x0E Get_Attribute_Single
0x10 Set_Attribute_Single
The following table shows the assignment between the IO points of the direction register and the instances and
the pin assignment of the ports.
Ports/Pins IO LED Assembly Bit DIP/DOP Instance
0 / 2 0.0 0 1
0 / 4 1.0 8 3
1 / 2 0.1 1 2
1 / 4 1.1 9 4
8.11.1 Configuration assembly for ZAC50EN01 and ZAC50EN02
The configuration of the inputs/outputs is made via a configuration assembly 100.
Configuration Assembly (0x64)
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 Direction Access (Byte 0), (0=input (def.), 1=output)
1 Direction Access (Byte 1), (0=input (def.), 1=output)
2 Reserved PM 0=off
1=on
3 PoE Enable/Disable (0=disable, 1=enable)
The abbreviation PM in the table refers to Power Monitoring.
8.11.2 Configuration assembly for ZAC51EN01
Configuration Assembly (0x64)
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 Direction Access (Byte 0) (see above)
1 Direction Access (Byte 1) (see above)